Photovoltaic power station light-driven rotating bracket

What rack configurations are used in photovoltaic plants?

The most used rack configurations in photovoltaic plants are the 2 V × 12 configuration (2 vertically modules in each row and 12 modules per row) and the 3 V × 8 configuration (3 vertically consecutive modules in each row and 8 modules per row). Codes and standards have been used for the structural analysis of these rack configurations.

What is cable-supported photovoltaic (PV)?

Cable-supported photovoltaic (PV) modules have been proposed to replace traditional beam-supported PV modules. The new system uses suspension cables to bear the loads of the PV modules and therefore has the characteristics of a long span, light weight, strong load capacity, and adaptability to complex terrains.

Does a ground-mounted photovoltaic power plant have a fixed tilt angle?

A ground-mounted photovoltaic power plant comprises a large number of components such as: photovoltaic modules, mounting systems, inverters, power transformer. Therefore its optimization may have different approaches. In this paper, the mounting system with a fixed tilt angle has been studied.

What are the characteristics of a cable-supported photovoltaic system?

Long span, light weight, strong load capacity, and adaptability to complex terrains. The nonlinear stiffness of the new cable-supported photovoltaic system is revealed. The failure mode of the new structure is discussed in detail. Dynamic characteristics and bearing capacity of the new structure are investigated.

What is a fixed mounted PV system?

Fixed mounted PV systems are the traditional and most widely used PV system. They are usually mounted on the ground and building roofs. Ground-mounted PV systems have been widely used in large-scale solar farms in deserts, open areas and mountains. These systems are cost-effective and easy to construct.

What is a new cable supported PV structure?

New cable supported PV structures: (a) front view of one span of new PV modules; (b) cross-section of three cables anchored to the beam; (c) cross-section of two different sizes of triangle brackets. The system fully utilizes the strong tension ability of cables and improves the safety of the structure.