Photovoltaic panel mounting tool assembly diagram

What is a power rail PV module mounting system?

The PV module mounting system engineered to reduce installation costs and provide maximum strength for parallel-to-roof, tilt up, or open structure mounting applications. The POWER RAIL mounting system is designed with the professional PV solar installer in mind.

Can a racking system be used to ground a PV module?

This racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with the included instructions. The system is a non-separately derived system.

How to mount solar modules on a roof?

Mounting diagram There are various possibilities for the arrangement of the mounting system and the modules on the roof. The most common option is to horizontally assemble type TF50+ carrier rails and arrange solar modules vertically. For this reason, any further mounting procedures describe such an arrangement.

Which materials should be used to install photovoltaic modules?

JA Solar recommends that when installing modules at the seaside, stainless steel or aluminum materials should be used to contact the photovoltaic modules, and the installation parts should be well protected from corrosion. The tilt angle of the modules is measured between the surface of the modules and a horizontal ground surface.

How do I mount a module?

Module mounting must use the pre-drilled mounting holes (Length * Width: 14mm x 9mm) in the frame. The most common mounting is achieved by mounting the module using the four symmetry points close to the inner side on module frame. Refer to the following picture for more details. Note that the holes in the center (blue) are for grounding.

Can a dynobondtm be used to ground a PV module?

The DynoBondTM is engineered for commercial and residential applications. Solar Stack racking system may be used to ground and/or mount a PV module complying with UL 1703 only when the specic module has been evaluated for grounding and/or mounting in compliance with UL 1703.